<p>I was looking into the Part Time Programs at U of Chicago, NYU, NWU, UCLA and wanted to get an idea what sort of student profile they are looking for.</p>
<p>Also Booth has a mandatory interview for all part time candidates, so if you have any idea of the sort of questions to expect that would be very helpful input. </p>
<p>My last question is how do professional certifications such as the CFA play into admissions, would it help offset a below average undergraduate GPA (in finance and op management)?</p>
<p>I am also considering the same schools for part-time, in addition to Berkeley. </p>
<p>I would say that if you look through the profiles of students at these schools they tend to:
Be slightly older/have more experience than your full time MBAs (by 1-3 years…so not that much)
stats tend to be slightly lower (for example at Booth 80% of full time MBAs fall in the 660-760 range while the part-time range is 620 and 740).
work experience tends to be a lot more industry focused as opposed to consulting/banking experience that you see in the full-time programs.</p>
<p>I think as long as you have solid/interesting work experience, a good GMAT, and a compelling story as to why a part-time program then you should be fine…even off setting a below average UG GPA…certifications like a CFA help but they aren’t going to be a big factor. </p>
<p>Does anyone know about the reputation and job prospects of Georgetown part-time MBA? It appears to be right in between top tier and second tier schools.</p>
<p>A question is the value of a non-MBA masters from a good school to raise my GPA and overall CV. I would ideally go directly into a tier 1 MBA program but am considering a detour to increase my chances. I have been accepted to Carnegie Mellons Masters in Information Technology program, which is congruent with my career path. Would getting a very high GPA from CMU significantly help my chances? I would hope a committee would consider how I have grown academically over the years.</p>
<p>I’m also going to post this as a dedicated thread.</p>